Adjusting Trigger Pull

Adjusting Trigger Pull

Postby bassbucks » October 9th, 2015, 2:36 pm

I adjusted the trigger pull slightly making it lighter and in doing so it caused the flit safety to stop working. Anyone know why and how to fix it?

Thanks,

Bass
bassbucks
 
Posts: 13
Joined: September 27th, 2015, 3:10 pm

Re: Adjusting Trigger Pull

Postby a1smokepole » October 9th, 2015, 5:33 pm

Do you have the trigger with the two screws on the front of the trigger and one on the back.
a1smokepole
 
Posts: 197
Joined: February 23rd, 2012, 6:29 pm
Location: Mandeville La.

Re: Adjusting Trigger Pull

Postby bassbucks » October 9th, 2015, 7:20 pm

Yes.

Also I was just now reading the manual and it said to only send the trigger in to Knight to have it adjuster.

Thanks,

Bass
bassbucks
 
Posts: 13
Joined: September 27th, 2015, 3:10 pm

Re: Adjusting Trigger Pull

Postby bassbucks » October 10th, 2015, 9:13 am

Let's try tat again.

Yes.

Also I was just now reading the manual and it said to only send the trigger to Knight to have it adjusted.

There.....that's better.

Bass
bassbucks
 
Posts: 13
Joined: September 27th, 2015, 3:10 pm

Re: Adjusting Trigger Pull

Postby a1smokepole » October 10th, 2015, 2:39 pm

Every time you adjust the trigger weight you have to adjust backlash don't touch the back screw sear adjustment. 1 front bottom screw first you screw out to lighting trigger weight. 2 then the top front screw is backlash you screw this all the way in then depress the trigger and slowly start to screw out on the backlash screw tell the trigger goes off stop check trigger weight and see if its were you what it. not there start over. I would not go under 2 LBS
a1smokepole
 
Posts: 197
Joined: February 23rd, 2012, 6:29 pm
Location: Mandeville La.


Return to Mountaineer

Who is online

Users browsing this forum: No registered users and 0 guests


cron